Measure and record the resistance of the resistors listed in Table 31-1. Then check your diode with...

Question

Measure and record the resistance of the resistors listed in Table 31-1. Then check your diode with the ohmmeter. Select a low ohm range and measure the forward and reverse resistance by reversing the diode. The diode is good on this test if the resistance is significantly different between the forward and the reverse directions. If you are using an autoranging meter. the meter may not produce enough voltage to overcome the barrier potential. You should select a low ohm range and hold that range. Consult the operator's manual for specific instructions. Record the data in Table 31— 1

Robert · Accepted Answer

New Doc 2017-06-06
Scanned by CamScanner

Measure and record the resistance of the resistors listed in Table 31-1. Then check your diode with the ohmmeter. Select a low ohm range and measure the forward and reverse resistance by reversing the...

Solution

Answer To This Question Is Available To Download

Related Questions & Answers

Submit New Assignment