LAB 1 – VLAN Configuration
Build your network in Cisco Packet Tracer using the below topology and configure IP addresses on all
devices by following the Addressing Table
Learning Objectives
Upon completion of this lab, you will be able to:
• Add and connect switches
• Add and connect PCs
• Verify basic device configuration and connectivity
• Configure and verify port security
• Configure VLANs on the switches
• Configure trunks on the switches
• Verify end-to-end connectivity
Task 1: Add and Connect the Switches and PCs
Task 2: Configure Devices and Verify Connectivity
Step 1. Configure each switch with the following basic settings:
• Hostname
• Banner
• Enable secret
• Line configurations
• Service encryption
Step 2. Configure the management VLAN interface on S1, S2, and S3
• Configure VLAN 99 as the management VLAN interface on S1, S2, and S3. This interface is not
active until after trunking is configured later in the activity. However, activate the interface at
this time with the appropriate command.
Step 3. Configure PC IP addressing