CIEN 202
Final Project
CE 103 Civil 3D
B. Dockte
Design a By Pass Road (File: I- Roadway Alignments
And Profiles-EX5(1)) Follow the instructed steps listed
in Assignments #7 - #10 and Lectures #11 - #14.
By-pass
Road
Design Requirements
• Design a road to by-pass 8th Avenue and
avoid the subdivision.
• At the completion of your final drawing
you will have a road with a co
idor and
all associated tables including Profile,
Sections at 50-foot intervals and
Quantities Tables.
Design Requirements - Alignment
• Start the by-pass road with an intersection
point at station 5+00 on 8th Avenue. The
intersection should be approximately
perpendicular to 8th Avenue and proceed north.
• End the by-pass road with an intersection point
at Station 20+00 on 8th Avenue. Make the
intersection approximately perpendicular to 8th
Avenue at that point.
Create the Alignment from a
Polyline
Start
Finish
Example Profile
Design Requirements - Assembly
• Create a road assembly with two 14 foot lanes, cu
,
a 5 foot sidewalk on both sides with a 5 foot buffer on
either side of the sidewalk. 30 mph design speed.
• Daylight into the existing surface.
• Use a -2% slope for the lane, a -4% slope for the cu
and a +2% slope for the sidewalk with a 5-foot buffer
on either side of the sidewalk. Use a 4:1 slope for the
daylight.
• Make the Pave 1 thickness 5 inches, the Base
thickness 6 inches, and the Su
ase thickness 1 foot.
Design Requirements – Material Lists
• Set up material lists (on the sample lines
properties page) for the cut and fill and the
pavement quantities (Pave 1, Base 1, and
Su
ase 1).
• Create quantities tables for the cut and fill and
the pavement quantities.
Include the following in your
assignment report.
• Submit your final drawing on line.
Example of Finished Drawing
Final Project
Design a By Pass Road (File: I- Roadway Alignments And Profiles-EX5(1)) Follow the instructed steps listed in Assignments #7 - #10 and Lectures #11 - #14.
Design Requirements
Design Requirements - Alignment
Create the Alignment from a Polyline
Example Profile
Design Requirements - Assembly
Design Requirements – Material Lists
Include the following in your assignment report.
Example of Finished Drawing